Microscan MS-3 Manual Book page 13

Chapter
1
Step 1 Hardware Required ..........................................................................1-2
Step 2 Connect the System.........................................................................1-3
Step 3 Initiate Communications...................................................................1-4
Step 4 Position Symbol and Scanner ..........................................................1-5
Step 5 Start Calibration ...............................................................................1-6
Step 6 Test for Read Rate...........................................................................1-7
Step 7 Save Settings...................................................................................1-8
This section is designed to get your scanner up and running quickly the user can get a
sense of its capabilities and test sample bar code symbols. Detailed setup information
for configuring the scanner for your specific application can be obtained in the subse-
quent chapters.
Note: You can learn the current setting of any parameter by inserting a question
mark after the number, as in <K100?>
MS-3 Laser Scanner User's Manual
Quick Start
Chapter Contents
To see all "K" commands, send <K?>.
1-1