Chapter 3
Startup and Configuration
This chapter provides procedures for starting up, calibrating, configuring, verifying, and
powering down the Waters 717plus Autosampler.
3.1 Powering Up the Autosampler
Note:
If the 717plus Autosampler is part of an IEEE-488 system, power up the 717plus
Autosampler before powering up the system controller.
Powerup
To power up the 717plus Autosampler:
1. Press the
2. Wait for the initializing sequence to complete and the IDLE message to appear in
the upper-left corner
1/0
(on/off) switch
(Figure
Waters 717plus
Figure 3-1 Power Switch Location
(Figure
3-2).
3-1) on the front panel.
Autosampler
Home
1
2
3
CAROUSEL
4
5
6
Release
7
8
9
Engage
0
Clear
Enter
Power
I
0
Switch
Powering Up the Autosampler
3
55