Setting Parameters For Lc System Operation - Waters 717plus Operator's Manual

Table 3-2 Configuration Parameters (Continued)
Parameter
Loop Volume?
Installed IEEE
Address
Desired IEEE Address

3.6.2 Setting Parameters for LC System Operation

To communicate with other LC system components:
• Set Report Delay for data integrators
• Set terminal strip signal parameters for Hold, Injection Start, and Injection Stop
• Set IEEE-488 address
Setting Report Delay
The Report Delay provides time for the data integrator to process data from a run before a
new injection begins.
If a data integrator is attached to the LC system, set the delay as follows:
1. From the 717plus Main Menu, press Config Page.
2. On Configuration Page 1
delay time in minutes.
Configuration
Page
3 Set equal to installed sample loop size. See
Section 4.8.2, Microbore/Semiprep
4 Displays current address. See
Parameters for LC System
4 Sets new IEEE address. See
Parameters for LC System
(Figure 3-9), highlight the Report Delay field and enter the
Description
Injections.
Section 3.6.2, Setting
Operation.
Section 3.6.2, Setting
Operation.
Startup and Configuration
3
68