Microbore/Semiprep Injections - Waters 717plus Operator's Manual

2. Set the sample chamber temperature on Configuration Page 2 by pressing the keys
indicated in
3. Close the sample compartment door.
Note: The heater/cooler shuts off if the sample compartment door is left open more
than 5 minutes
4. Wait for the sample compartment to reach the set point. The heater/cooler may
require up to 90 minutes to reach 4° C from an ambient temperature of 27° C.

4.8.2 Microbore/Semiprep Injections

The Waters 717plus Autosampler may be physically reconfigured to facilitate microbore
injections (< 5 µL) and semiprep injections (> 150 µL).
Figure 4-25.
Menu: Main
Configuration
Page 1
I D L E
E d i t : C o n f i g u r a t i o n P a g e 2 o f 4
H o l d C o n t a c t S e n s e ? +
H o l d I n p u t
O n
I n j e c t S t a r t P u l s e ( s e c ) : 0 . 5
E n d o f R u b P u l s e ( s e c ) : 0 . 5
Te m p S e t p o i n t ( i C ) : 8
Te m p C o n t r o l ? O n
P r e v C f g N e x t C f g
P a g e P a g e
Figure 4-25 Setting Sample Chamber Temperature
Config
Page
NextCfg
Page
–
O f f
3 0
N o
2 0
O f f
8
O n
M a i n
P a g e
Operating the Autosampler
4
120