Table of Contents
Advertisement
TIMETRAX PRO
INSTALLING THE TIME RECORDER
The TimeTrax series time recorder can be mounted on a wall using the mount-
ing bracket or set on a desk using the rubber feet. The communications and
power cables may be routed through the hole in the bottom of the time
recorder or through the cutout in the mounting bracket and through the wall.
The mounting bracket features a locking tab that prevents the time recorder
from being removed once it is attached. A wall bracket release key is provided to
disengage the lock tab for removing the unit.
INSTALLING THE MOUNTING BRACKET
1. Hold the mounting bracket flush against the wall with the cable access cut
out to your left, the locking tab to your right and extended downward, with
the four mounting tabs on the corners extended upward. Level bracket, if
you are going to pre-drill holes for screws or anchors. Use a pencil to mark
the four screw holes close to the corner tabs. If you are going to run cables
through the wall, also mark the rectangular cable access cutout.
2. If needed, drill holes as marked for the four mounting screws and insert the
anchors.
3. If needed, drill and/or cut a hole centered in the rectangular mark drawn for
cable access. The hole should be big enough to allow you to conveniently
route the cables through the wall.
4. Screw the mounting bracket to the wall.
2
BuyOnlineNow.com
Advertisement
Table of Contents
Troubleshooting
