Timetrax Ethernet Time Recorder - Pyramid TimeTrax pro Reference Manual

TIMETRAX PRO

TIMETRAX ETHERNET TIME RECORDER

This product requires a network that has a DHCP server and that the server is
enabled. The clock will automatically locate the DHCP and the DHCP will assign
an IP address to the clock. The clock(s) and its corresponding IP Address will be
displayed on the Initial Communications Screen upon login. Also, the computer
and all Time Recorders must be on the same subnet.
* DO NOT PLUG IN THE POWER CORD UNTIL THE SOFTWARE
IS INSTALLED AND THE ETHERNET CABLE IS CONNECTED
PROPERLY TO THE TIME RECORDER*
*Note: If you plug in the power cord first, the correct IP address will not
be found and the software will not recognize the clock. You will
have to disconnect the power and wait approximately 1 hour
before attempting again.
INSTALLATION INSTRUCTIONS
It is important when installing your Pyramid TimeTrax Recorder(s) that you
follow the instructions below, in the order listed to make sure that the system
locates the correct IP address and functions correctly.
1. Install the TimeTrax software to the designated computer(s). Exit the
TimeTrax software.
2. Mount each Time Recorder according to the mounting instructions located
in this manual.
3. Plug the Ethernet cable that connects to your network into the Cat5 jack
of each TimeTrax, labeled "Ethernet". DO NOT ATTACH THE POWER
CORD YET!
4. Attach power cord to the first Ethernet Time Recorder and plug opposite end
into 120 volt A/C outlet. Let it run for at least 3 minutes. (Leave all other
Ethernet Time Recorders unpowered.)
5. Open the TimeTrax program. Log into the software as the PRIMARY
ADMINISTRATOR (e.g. User Admin, password PTI). Select LOG IN.
6. Confirm that the recorder appears in the Initial Time Recorder Connection
Form. If not, click the RECONNECT button.
7. Allow the Initial Time Recorder Connection Form to remain on screen.
58
BuyOnlineNow.com