Agilent Technologies E4419B User Manual page 158

Menu Reference
Front Panel Menu Reference "System/Inputs" Menu
Display
Press this softkey to access a menu which allows you to set the
defaults for contrast and brightness.
Press this softkey to increase the display contrast.
Press this softkey to decrease the display contrast.
Set Contrast
Press this softkey to set the default contrast to that currently
displayed. Note, this key changes the factory default setting.
Set Brightness
Press this softkey to set the brightness. Note, this key
changes the factory default setting.
Version
Press this softkey to display: the model number; option
structure; serial number; firmware, bootrom and DSP
revisions.
Serial Diagnostic
Press this softkey to access a diagnostic menu for the serial
interface (RS232/RS422). This softkey is greyed out if GP-IB
has been selected as the remote control interface.
Tx Break
Press this softkey to transmit a break sequence from the
serial port to the external receiver.
Status
Press this softkey to produce a screen showing the state of
the UART line and modem status registers. If the Xon/Xoff
handshake is enabled, the screen also shows the state of Rx
and Tx.
Reset
Press this softkey to reset and initialize the UART and to
flush both the receiver and transmitter buffers.
Interface Overview
Press this softkey to produce a screen showing a summary of
the remote interface configuration.
3-32 Agilent E4419B User's Guide