Agilent Technologies E4419B User Manual page 147

System
Inputs
The softkey menu structured to this hardkey affects the system setup and
the channel setup.
Press this hardkey to access the "System/Inputs" menu. This menu allows
you to set up a variety of conditions for your power meter, for example:
GP-IB address, serial interface parameters, sensor calibration tables,
averaging, duty cycle, range, offset, service. It also allows you to review
errors.
•
Remote Interface
Press this softkey to access a menu which allows you to select and
configure the remote interface, select the command set you want
to use, or obtain an interface overview
Command Set
Press this softkey to access a menu which allows you to select
the remote programming language you want to use. Refer to
"Programming Language Selection", on page 2-64 for further
information.
SCPI
Press this softkey to select SCPI (Standard Commands for
Programmable Instruments) as the remote programming
language you want to use.
HP 438A
Press this softkey to select the Agilent 438A emulation
mode. In this mode the power meter responds to the Agilent
438A programming command set.
Select Interface
Press this softkey to access a menu which allows you to select
between GP-IB, RS232 and RS422 as the remote interfaace
standard.
GP-IB
Press this softkey to select the GP-IB port for remote
operation.
RS232
Press this softkey to select the serial port for remote
operation using the RS232 Standard.
Agilent E4419B User's Guide
Front Panel Menu Reference "System/Inputs" Menu
Menu Reference
3-21