Agilent Technologies E4419B User Manual page 96

Power Meter Operation
Selecting a Digital or Analog Display
To select the format of the display in the currently selected window:
Meas
1. Press ,
Setup
2. Press
Meter Dgtl Anlg
require. Pressing this key toggles between a digital and analog
display.
To select the range of the analog display in the currently selected window:
Meas
1. Press ,
Setup
2. The current setting of the maximum and minimum values
displayed on the analog meter are displayed under the
softkeys respectively.
Min
3. To change either of these settings press the appropriate softkey.
The power meter displays the current value in a pop up window.
Modify this value (see below) until the desired value is displayed.
Use
currently positioned.
Use
4. The choices available depend on the unit of measurement selected
and the current measurement mode. If the measurement unit
selected is logarithmic, then the choice will be
measurement unit selected is linear, then choose the appropriate
softkeys from the following menus:
More
Pressing
Increment Multiplier
Decrement Multiplier
2-56
.
Display Format
to highlight the type of format you
,
Display Format
or to modify the digit on which the cursor is
or to move to other digits.
%
Cancel
%
Increment
Multiplier
Decrement
Multiplier
Cancel
increases or decreases the multiplier
Anlg Mtr Scaling
or
dB dBm
mW
µW
nW
Cancel
W
Increment
Multiplier
More
Decrement
Multiplier
Cancel
or
Agilent E4419B User's Guide
.
and
Max
. If the