Table 2-12: Output Commands; Table 2-13: Source Commands - Tektronix AWG710 Programmer's Manual

Command Groups
Output Commands
Source Commands
2-20
The Output commands control the characteristics of the waveform output port.

Table 2-12: Output commands

Header
OUTPut[1]:FILTer[:LPASs]
:FREQuency (?)
OUTPut[1][:STATe] (?)
OUTPut[1]:ISTate (?)
The Source commands set waveform and marker output parameters, such as
frequency and level.

Table 2-13: Source commands

Header
[SOURce[1]]:FREQuency
[:CW|:FIXed](?)
[SOURce[1]]:FUNCtion:USER (?)
[SOURce[1]]:MARKer[1|2]
[:LEVEL][:IMMediate]:HIGH (?)
[SOURce[1]]:MARKer[1|2]
[:LEVEL][:IMMediate]:LOW (?)
[SOURce[1]]:ROSCillator
:SOURce (?)
[SOURce[1]]:VOLTage[:LEVel]
[:Immediate][:AMPLitude] (?)
[SOURce[1]]:VOLTage[:LEVel]
[:Immediate]:OFFSet (?)
AWG710 Arbitrary Waveform Generator Programmer Manual
Description
Determine the cutoff frequency of the low pass filter
Control whether the output terminal is open or
closed
Set the inverted output on or off
Description
Set sampling frequency for outputting waveform
Specify the user defined waveform or pattern file
Set high level for marker output
Set low level for marker output
Select the reference oscillator source
Set the actual magnitude of the output signal
Set the offset that is added to the output signal