Tektronix AWG710 Programmer's Manual page 144

Data Transfer
Waveform Generator to
External Device
2-114
Use the following command to transfer data from the waveform generator to the
external controller.
MMEMory:DATA? <file_name>
This command uploads the file <file_name> on the internal hard disk, floppy
disk, or the network drive. The response format is in IEEE488.2 block format.
For example, the following command string will upload the file FILE-AWG on
the waveform generator to the external controller.
MMEMory:DATA? "FILE AWG"
AWG710 Arbitrary Waveform Generator Programmer Manual