Service-Policy - Cisco Nexus 7000 Series Command Reference Manual

service-policy

S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m .
service-policy
To attach a policy map to an interface, VLAN, or tunnel, use the service-policy command. To remove a
service-policy from an interface, VLAN or tunnel, use the no form of this command.
Syntax Description type
qos
queuing
input
output
policy-map-name
qos-dynamic
no-stats
Defaults
type default is qos.
No policies of type qos are active on an interface until the service-policy command is entered. The
system-defined type queuing class maps are attached to each interface unless you specifically attach a
different class map. For a list of the system-defined type queuing class maps, see
Command Modes
Interface configuration
VLAN configuration
Supported User Roles
network-admin
vdc-admin
Command History Release
4.0
4.0(3)
4.2(1)
Cisco Nexus 7000 Series NX-OS Quality of Service Command Reference, Release 5.x
QOS-72
service-policy [type {qos | queuing}] {input | output} {policy-map-name | qos-dynamic}
[no-stats]
no service-policy [type {qos | queuing}] {input | output} {policy-map-name | qos-dynamic}
[no-stats]
(Optional) Specifies whether the policy map is of type qos or queuing.
Specifies a policy map of type qos.
Specifies a policy map of type queuing.
Applies this policy map to packets coming into this interface.
Applies this policy map to packets going out of this interface.
Name of the policy map to attach to this interface. Only one policy map can
be attached to the input and one to the output of a given interface for each
of the policy type qos and queuing.
Specifies already configured policy maps.
(Optional) Disables generation of statistics for this policy map.
Modification
This command was introduced.
Support for tunnel interfaces is added.
The qos-dynamic variable was added.
Cisco Nexus 7000 Series NX-OS Quality of Service Commands
Table 1.
OL-23378-01