Cisco Nexus 7000 Series Command Reference Manual page 15

Cisco Nexus 7000 Series NX-OS Quality of Service Commands
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m .
bandwidth remaining
To configure the percentage of the bandwidth remaining on the interface after other allocations are
configured on both ingress and egress queues, use the bandwidth remaining command. To remove the
remaining bandwidth allocation, use the no form of this command.
Syntax Description
percent
Defaults
None
Command Modes Policy map type queuing class configuration
Supported User Roles network-admin
vdc-admin
Command History Release
4.0
Usage Guidelines
You can use the system-defined ingress or egress queue class for the type of module to which you want
to apply the policy map. For more information about system-defined type queuing class maps
Table
For more information on using this command, see the Cisco Nexus 7000 Series NX-OS Quality of Service
Configuration Guide, Release 5.x.
This command does not require a license.
Examples
This example shows how to set the bandwidth remaining for the specified queue:
switch(config)# policy-map type queuing my_policy1
switch(config-pmap-que)# class type queuing 1p7q4t-out-pq1
switch(config-pmap-c-que)# bandwidth remaining percent 25
This example shows how to remove the bandwidth remaining for the specified queue:
switch(config)# policy-map type queuing my_policy1
switch(config-pmap-que)# class type queuing 1p7q4t-out-pq1
switch(config-pmap-c-que)# no bandwidth remaining percent 25
OL-23378-01
bandwidth remaining percent {percent}
no bandwidth remaining percent {percent}
Percentage of remaining bandwidth on the underlying link. Valid values are
from 0 to 100.
Modification
This command was introduced.
1. You can use this command with the priority command.
Cisco Nexus 7000 Series NX-OS Quality of Service Command Reference, Release 5.x
bandwidth remaining
, see
QOS-5