Ford Aerostar 1997 Workshop Manual page 63

1997 Aerostar/Ranger
1. NOTE: Lightly oil all bolt and stud threads before installation.
Clean mating surfaces on the exhaust manifold, cylinder head (6049) and exhaust inlet pipe (5246).
2. Position exhaust manifold on the cylinder head and install manifold attaching bolts. Tighten to 25 Nm
(18 lb-ft).
3. Connect exhaust inlet pipe to the exhaust manifold. Tighten the attaching nuts to 27 Nm (20 lb-ft).
4. Install heater hose support bracket.
5. Connect heater water hose.
6. Fill and bleed cooling system. Refer to
7. Start engine (6007) and check for exhaust and coolant leaks.
file://C:\TSO\tsocache\VDTOM_5368\SVK~us~en~file=SVK31C26.HTM~gen~ref.HTM
Section 03-03 .
tomsn048@gmail.com
Page 2 of 2
2011-04-27