1997 Aerostar/Ranger
A
—
B
—
C
—
4. NOTE: Normal CID sensor rotation is clockwise viewed from top of CID sensor.
Align the CID sensor rotor as shown with the trailing edge of the vane lined up with the short mark at
the left hand side of the plastic window.
5. Position the sensor above its hole at right angles to the block rear face.
6. Install the assembled CID sensor and oil pump drive gear into the engine. As the assembly is pushed
into place, the camshaft gear will rotate the sensor vane clockwise toward the center of the window.
file://C:\TSO\tsocache\VDTOM_5368\SVK~us~en~file=SVK31C45.HTM~gen~ref.HTM
Tighten to 17-21 Nm
(13-15 Lb-Ft)
Maximum Level for Pre-Oiling Drive Gear
Minimum Level for Pre-Oiling Drive Gear
tomsn048@gmail.com
Page 30 of 34
2011-04-27