Ford Aerostar 1997 Workshop Manual page 33

1997 Aerostar/Ranger
Lubricate seal lip with clean engine oil XO-5W30-QSP or equivalent meeting Ford specification ESE-
M2C153-E or SAE 5W-30 Service SG engine oil and install crankshaft front seal using Front Cover
Aligner T74P-6019-A and Crankshaft Front Seal Installer T90T-6701-A.
3. Coat crankshaft damper sealing surface with clean engine oil XO-5W30-QSP or equivalent meeting
Ford specification ESE-M2C153-E or SAE 5W-30 Service SG engine oil. Apply RTV using Rotunda
RTV Dispenser or equivalent to keyway of damper prior to installation. Install damper using
Crankshaft Damper Replacer T74P-6316-B. Install damper attaching bolt and tighten to 40-50 Nm
(30-37 lb-ft), then turn bolt an additional 80-90 degrees tighter.
4. Install accessory drive belt over pulleys. Make sure that all V-grooves make proper contact with
pulley.
5. Lift tensioner and slide belt under tensioner pulley. Release tensioner to rest pulley on belt.
6. Start engine and check for oil leaks.
file://C:\TSO\tsocache\VDTOM_5368\SVK~us~en~file=SVK31C20.HTM~gen~ref.HTM
tomsn048@gmail.com
Page 3 of 3
2011-04-27