Ford Aerostar 1997 Workshop Manual page 155

1997 Aerostar/Ranger
17. Install the timing chain guide with the guide pin in to the oil supply hole. Tighten guide bolts to 10-12
Nm (7-9 lb-ft).
18. Install camshaft sprocket, timing chain/belt (6268) and crankshaft sprocket. Position sprockets and
timing chain/belt on camshaft and crankshaft simultaneously.
19. NOTE: A packaging clip from a new automatic tensioner can be used to hold tensioner in a
retracted position. If a packaging clip is not available, fabricate a clip using shop materials.
With the timing chain vibration damper held in the retracted position with clip, install the tensioner and
tighten the bolts to 9-11 Nm (7-8 lb-ft).
20. Install the camshaft capscrew. Tighten camshaft capscrew to 60-68 Nm (44-50 lb-ft).
file://C:\TSO\tsocache\VDTOM_5368\SVK~us~en~file=SVK31C45.HTM~gen~ref.HTM
tomsn048@gmail.com
Page 6 of 34
2011-04-27