1997 Aerostar/Ranger
Item
Part Number
1
W702301S309M
2
12A648
3
10884
4
8501
5
—
6
9439
7
9424
A
—
B
—
5. Position the intake manifold with the aid of two guide studs located in position 3 and 4 below, and
install the bolts hand-tight. Then remove the two guide studs and replace with bolts. Tighten the
intake manifold bolts in three stages following the sequence shown.
file://C:\TSO\tsocache\VDTOM_5368\SVK~us~en~file=SVK31C19.HTM~gen~ref.HTM
Description
Bolt with Captive Washer (8)
Engine Coolant Temperature Sensor
Water Temperature Indicator Sender Unit
Water Pump
Stud (2) (Part of 9424)
Intake Manifold Gasket
Intake Manifold
Tighten to 16 Nm
(12 Lb-Ft)
Used to Locate Lower Intake Manifold Only
tomsn048@gmail.com
Page 5 of 7
2011-04-27