Ford Aerostar 1997 Workshop Manual page 130

1997 Aerostar/Ranger
21. Install accelerator cable bracket (9723) and tighten bolts to 21-27 Nm (15-20 lb-ft).
22. Install A/C compressor mounting bracket and brace with assembled power steering pump (3A674)
and A/C compressor. Tighten screws to 40-55 Nm (30-40 lb-ft).
23. Plug in compressor electrical connections.
24. Install warm air duct.
25. Connect heater water hose (18472) to water pump and other electrical and vacuum connections.
26. Install generator mounting bracket with assembled generator. Tighten bolts to 40-55 Nm (30-40 lb-ft).
27. Connect heater water hose to engine. Clip engine control sensor wiring to side of generator mounting
bracket.
28. Install drive belt over pulleys. Make sure that all V-grooves make proper contact with pulleys.
29. Lift tensioner and slide belt under tensioner pulley. Release drive belt tensioner (6B209) to rest on
belt.
30. Install air cleaner outlet tube, accelerator control splash shield, and radiator overflow hose.
31. Fill and bleed the cooling system. Refer to
and quantity of oil.
32. NOTE: When the battery has been disconnected and reconnected, some abnormal drive
symptoms may occur while the powertrain control module (PCM) (12A650) relearns its
adaptive strategy. The vehicle may need to be driven 16 km (10 miles) or more to relearn the
strategy.
Connect battery ground cable.
33. Charge air conditioning system, if so equipped as outlined in
34. Operate the engine at fast idle until it reaches normal operating temperature and check all gaskets
and hose connections for leaks.
35. Install and adjust the hood.
file://C:\TSO\tsocache\VDTOM_5368\SVK~us~en~file=SVK31C41.HTM~gen~ref.HTM
Section 03-03 . Fill the crankcase with the proper grade
Section 12-00
tomsn048@gmail.com
Page 4 of 5
.
2011-04-27