1997 Aerostar/Ranger
Section 03-01C: Engine, 4.0L V-6
IN-VEHICLE SERVICE
Sensors
Low Oil Level Sensor
Removal
1. With engine off, drain at least 1.9 liters (2 quarts) of oil from engine (6007).
2. Disconnect electrical connection.
3. Remove low oil level sensor (6C624) with a 26mm (1-inch) socket or end wrench. Discard old gasket.
Installation
1. NOTE: Always replace gasket when removing low oil level sensor.
Install new gasket onto low oil level sensor, noting flange faces sensor and the words "pan side" are
facing the oil pan (6675).
2. NOTE: When replacing low oil level sensor using a metal gasket with a rubber O-ring, tighten
sensor to 17-27 Nm (13-20 lb-ft).
Install low oil level sensor and gasket assembly. Tighten to 20-34 Nm (15-25 lb-ft).
3. Connect electrical connection.
4. Refill crankcase to correct level.
5. Start engine and check for oil leaks.
Typical Oil Level Sensor Installation
file://C:\TSO\tsocache\VDTOM_5368\SVK~us~en~file=SVK31C38.HTM~gen~ref.HTM
1997 Aerostar, Ranger Workshop Manual
tomsn048@gmail.com
Page 1 of 4
2011-04-27