1997 Aerostar/Ranger
Installation
Prior to installing camshaft rear bearing cover, the plug bore should be inspected for any damage that would
interfere with the proper sealing of the plug. If the bore is damaged it will be necessary to true the surface by
boring for the next specified oversize plug. Oversize (OS) plugs are identified by the OS stamped in the flat
located on the cup side of the plug.
1. Apply a light coating of Perfect-Seal Sealing Compound B5A-19554-A meeting Ford specifications
ESR-M18P2-A and ESE-M4G115-A or equivalent to the sealing edge of the camshaft rear bearing
cover before installation. Install bore camshaft rear bearing cover using a suitable driver.
2. Install flywheel or flexplate and flywheel reinforcing plate. Tighten flywheel-to-crankshaft bolts as
follows:
a. First stage — 12-15 Nm (9-11 lb-ft).
b. Second stage — 68-74 Nm (50-55 lb-ft).
3. If equipped, install clutch as outlined in
4. Install transmission. Refer to the applicable section in Group 07.
file://C:\TSO\tsocache\VDTOM_5368\SVK~us~en~file=SVK31C35.HTM~gen~ref.HTM
Section 08-01
.
tomsn048@gmail.com
Page 2 of 3
2011-04-27