Ford Aerostar 1997 Workshop Manual page 170

1997 Aerostar/Ranger
2 6049
3 6051
4 6A008
5 6500
6 6051
A —
46. Install and tighten the cylinder head bolts, in the sequence shown, in the following steps.
Step 1 — 30-35 Nm (22-26 lb-ft)
Step 2 — 70-75 Nm (52-56 lb-ft)
Step 3 — rotate bolts 90 degrees
47. NOTE: Once applied, the silicone sealer will set up in approximately 15 minutes. The intake
manifold must be installed immediately after the sealer is applied.
Apply Silicone Rubber D6AZ-19562-BA or equivalent meeting Ford specifications ESB-M4G92-A and
ESE-M4G195-A to the block and cylinder head mating surfaces at the four corners. Install the intake
manifold gasket (9439) and again apply sealer to the four corner locations.
file://C:\TSO\tsocache\VDTOM_5368\SVK~us~en~file=SVK31C45.HTM~gen~ref.HTM
Cylinder Head
Head Gasket (LH)
Cylinder Head to Block Dowel
Valve Tappet
Head Gasket (RH)
Installation Arrows (on Top) Must Point to Front of
Engine
tomsn048@gmail.com
Page 21 of 34
2011-04-27