Ford Aerostar 1997 Workshop Manual page 43

1997 Aerostar/Ranger
16. On Aerostar:
a. Install transmission as outlined in Group 07.
b. Install lower radiator hose.
c. Install water pump pulley. Tighten bolts to 22-28 Nm (17-21 lb-ft).
d. Install generator mounting bracket with assembled generator. Tighten bracket-to-cylinder head
bolts to 40-50 Nm (30-37 lb-ft).
e. Install drive belt tensioner. Tighten bolts to 40-50 Nm (30-40 lb-ft).
f. Install A/C compressor mounting bracket and brace with attached power steering pump and
A/C compressor. Tighten three bracket-to-cylinder head bolts and two bracket-to-front cover
nuts to 40-55 Nm (30-40 lb-ft).
g. Install fan shroud.
h. Install fan blade and fan clutch assembly using Fan Clutch Holding Tool T84T-6312-C and Fan
Clutch Nut Wrench T84T-6312-D. Tighten to 40-135 Nm (30-100 lb-ft).
17. Install drive belt over pulleys. Make sure that all V-grooves make proper contact with the pulleys.
18. Lift tensioner and slide drive belt under tensioner pulley. Release drive belt tensioner to rest pulley on
belt.
19. Install air cleaner outlet tube.
20. Refill cooling system. Start engine and check for leaks.
file://C:\TSO\tsocache\VDTOM_5368\SVK~us~en~file=SVK31C23.HTM~gen~ref.HTM
tomsn048@gmail.com
Page 3 of 5
2011-04-27