Ford Aerostar 1997 Workshop Manual page 5

1997 Aerostar/Ranger
Item Part Number
1 6582
2 E800390-S72
3 6582
4 W701041
5 9424
6 6049
7 6584
8 6582
9 6049
10 6010
A —
5. Install A/C air register impingement screen on A/C compressor mounting bracket and tighten
compressor bolts to 24-30 Nm (18-23 lb-ft).
6. Snap spark plug wires into clips on valve cover.
7. Install upper intake manifold as described in this section.
8. Apply Silicone Rubber D6AZ-19562-BA or equivalent meeting Ford specifications ESB-M4G92-A and
ESE-M4G195-A to right intake manifold-to-cylinder head parting seam.
9. Install left valve cover, bolts, and rocker arm cover flange plates and snug bolts starting from center
bolts and working in crisscross pattern to end bolts. Tighten in same pattern to 6-8 Nm (4.5-5.9 lb-ft).
10. Install ignition coil and assembled bracket and generator. Refer to
11. Snap spark plug wires into clips on valve cover.
12. Install oil fill pipe, oil level indicator tube, and transmission oil filler tube.
file://C:\TSO\tsocache\VDTOM_5368\SVK~us~en~file=SVK31C13.HTM~gen~ref.HTM
Description
Valve Cover — Aerostar (RH)
Screw, M 6 x 22 Flange Head
Valve Cover (LH)
Stud
Intake Manifold
Cylinder Head (RH)
Valve Cover Gasket
Valve Cover — Ranger (RH)
Cylinder Head (LH)
Cylinder Blocks
Tighten to 8-10 Nm
(71-89 Lb-In)
tomsn048@gmail.com
Page 2 of 3
Section 03-07C .
2011-04-27