Ford Aerostar 1997 Workshop Manual page 180

1997 Aerostar/Ranger
7. Rotate the CID sensor counterclockwise. Install clamp and screw finger-tight. Rotate the sensor back
to its position at right angles to the back of the block.
8. NOTE: For out of vehicle assembly, use loose 12 volt battery or battery in a conveniently
located vehicle.
Connect the CID Testing Wiring Harness T94T-50-B to the CID Sensor.
file://C:\TSO\tsocache\VDTOM_5368\SVK~us~en~file=SVK31C45.HTM~gen~ref.HTM
tomsn048@gmail.com
Page 31 of 34
2011-04-27