Ford Aerostar 1997 Workshop Manual page 166

1997 Aerostar/Ranger
7 —
8 6A674
9 6734
10 6730
11 6C629
A —
B —
C —
41. Install and seal the oil pan:
a. Place a bead of Ford Silicone Sealer F1AZ-19562-A meeting Ford specification WSE-
M4G320-A2 or Loctite® 598 sealer in the oil pan gasket groove at the radius areas at the front
and rear of the oil pan.
b. Place a bead of Ford Silicone Sealer F1AZ-19562-A meeting Ford specification WSE-
M4G320-A2 or Loctite® 598 on top of the oil pan gasket at the radius areas at the front and
rear of the oil pan.
c. Place a bead of Ford Silicone Sealer F1AZ-19562-A meeting Ford specification WSE-
M4G320-A2 or Loctite® 598 on the cylinder blocks at the cylinder block to front cover joint
area.
d. Set the oil pan in place and snug the 4 pan nuts. Ensure integral wedge seal is properly
located.
e. Align the rear face of the oil pan with the rear face of the cylinder blocks.
file://C:\TSO\tsocache\VDTOM_5368\SVK~us~en~file=SVK31C45.HTM~gen~ref.HTM
Stud (Part of 6010)
Clip
Oil Pan Drain Plug Gasket
Oil Pan Drain Plug
Torx® Bolt
Tighten to 7-10 Nm
(5-7 Lb-Ft)
Tighten to 17-21 Nm
(13-20 Lb-Ft)
Tighten to 4 Nm (35 Lb-In)
tomsn048@gmail.com
Page 17 of 34
2011-04-27