1997 Aerostar/Ranger
f. Install the remaining oil pan bolts and torque to 7-10 Nm (62-89 lb-ft).
42. NOTE: Always use a new rear main seal.
Refer to
Crankshaft Rear Oil Seal
43. NOTE: The transmission bolts to the engine and oil pan when installed, so it is important to
measure the difference between the surface of the rear face of the oil pan (at the spacer
locations) and the rear face of the cylinder blocks. If the rear face of the oil pan cannot be
aligned within .0100 in. of the rear face of the cylinder block, the appropriate shims must be
used. Refer to the following procedure for checking this dimension.
file://C:\TSO\tsocache\VDTOM_5368\SVK~us~en~file=SVK31C45.HTM~gen~ref.HTM
Installation in this section.
tomsn048@gmail.com
Page 18 of 34
2011-04-27