Ford Aerostar 1997 Workshop Manual page 136

1997 Aerostar/Ranger
34. Disconnect the transmission and transfer case electrical connectors.
35. Using Disconnect Tools D87L-9280-A and D87L-9280-B, disconnect the fuel supply and return lines
where the engine supply and return tubes connect to the chassis fuel lines to the left of the engine
near the frame. Refer to
36. Disconnect the accelerator cable (9A758) and accelerator cable bracket (9723) and position aside.
37. Disconnect the upper and lower heater water hoses (18472).
38. Disconnect the engine vacuum lines from the evaporative emissions canister (EVAP canister)
(9D653), lower intake manifold and the upper intake manifold vacuum outlet fitting and cap.
39. Remove the spark plug wires from the ignition coil (12029) assembly and disconnect and remove the
ignition coil assembly, with ignition coil mounting strap (12043).
40. Disconnect the electrical connector from the throttle body throttle position sensor (TP sensor)
(9B989).
41. Remove the throttle body (9E926) and upper intake manifold as an assembly.
42. Disconnect the fuel charging wiring connectors at both left front and right rear of engine.
43. Install engine lifting brackets on the right front and left rear of the engine (6007) and remove from the
vehicle.
file://C:\TSO\tsocache\VDTOM_5368\SVK~us~en~file=SVK31C42.HTM~gen~ref.HTM
Section 03-04C .
tomsn048@gmail.com
Page 5 of 10
2011-04-27