Ford Aerostar 1997 Workshop Manual page 116

1997 Aerostar/Ranger
4 —
5 —
6 6262
7 —
8 —
Installation
The camshaft bearings are available pre-finished to size and require no reaming for standard and 0.081mm
(0.015 inch) undersize journal diameters.
1. NOTE: Align the oil holes in the camshaft bearings with the oil holes in the cylinder blocks
(6010) before pressing bearings into place.
Make sure the front bearing is installed 0.51-0.89mm (0.020-0.035 inches) below the front face of the
cylinder block.
Position camshaft bearings at the bearing bores and press them in place with Camshaft Bearing Set
T65L-6250-A. Be sure to center the pulling plate and puller screw to avoid damage to the bearing.
Failure to use the correct expanding collet can cause severe bearing damage.
2. Install camshaft rear bearing cover as outlined.
file://C:\TSO\tsocache\VDTOM_5368\SVK~us~en~file=SVK31C39.HTM~gen~ref.HTM
Expanding Collet
(Part of T65L-6250-A)
Backup Nut
(Part of T65L-6250-A)
Bearing, Camshaft
(Part Number Given Is for Reference Only)
Puller Screw Extension
(Part of T65L-6250-A)
Front Spacer
(Part of T65L-6250-A)
NOTE: All items except No. 6 (Bearing) are included in
Camshaft Bearing Set T65L-6250-A.
tomsn048@gmail.com
Page 2 of 3
2011-04-27