Alcatel-Lucent 7750 SR-a4 Installation Manual page 197

7750 SR-a4 and SR-a8 Installation Guide
Step 1. If the system has a single CPM-a and you have a spare CPM-a with the appropriate
CF card, install the spare CPM-a in the empty CPM-a slot; see
on page 194.
Step 2. Remove the CPM-a that has the compact flash that you need to replace and place it
on a flat antistatic work surface; see
Step 3. Remove the new CF card from the packaging and place it on a flat anti-static work
surface.
Step 4. Remove the CF card that is being replaced by doing the following; see
for its location on the CPM-a.
i. Lift the card retainer bail that covers the CF card slot (Key 1 on
ii. Use a pair of pliers or tweezers to pull the CF card out of the slot (Key 2 on
Figure 72). (The card is intentionally difficult to remove.)
iii. Place the extracted CF card on a flat antistatic work surface.
Step 5. Insert the new CF card into the slot until it is fully seated.
Step 6. Close the card retainer bail to hold the CF card in the slot.
Step 7. If you installed a spare CPM-a in
193.
Step 8. Reinstall the CPM-a that has the new CF card; see
Appendix C: Field-Replaceable Units
Removing a CPM-a on page
Step 1, remove it; see Removing a CPM-a on page
Replacing a CPM-a on page
Replacing a CPM-a
193.
Figure 72
Figure 72).
194.
197