Warnings and Notes
Warnings and Notes
108
Danger:
•
Only trained and qualified personnel should install or replace this equipment.
•
Invisible laser radiation can be emitted from the aperture ports when no cable is
connected. Avoid exposure and do not stare into open apertures.
•
Install the components after the 7750 SR-a chassis has been installed in the rack.
•
Do not power up a 7750 SR-a router until all components are installed and verified.
•
Before you perform any procedures in this chapter, ensure that you comply with the
general safety precautions and product requirements described in
page 47
.
Warning:
•
Electrostatic discharge (ESD) damage can occur if MDA-a cards are mishandled.
Always wear an ESD-preventive wrist or ankle strap and always connect an ESD strap
to the grounding plug on the front of the chassis.
•
Place the 7750 SR-a components on an antistatic surface during installation.
•
Do not over-tighten the captive screws when securing modules.
Note:
•
Alcatel-Lucent recommends that you read the following sections in the Overview
chapter for detailed information and specific requirements that apply to the 7750 SR-a
components:
→
CPM-a on page 31
IOM-a on page 35
→
→
MDA-a Cards on page 36
Fan Trays on page 40
→
Impedance Panels on page 43
→
•
If you need to remove or replace an installed component, refer to
Field-Replaceable Units on page 171
•
Empty slots in the chassis must be covered by impedance panels. Panels must be
ordered separately. See
.
Impedance Panels on page 43
7750 SR-a4 and SR-a8 Installation Guide
Site Preparation on
Appendix C:
for more information.