Installing the Internal CF Card on the CPM-a
7750 SR-a4 and SR-a8 Installation Guide
The CPM-a supports an internal CF card that contains the boot file that is required to boot the
7750 SR-a at startup.
The CF card is shipped separately from the chassis and the CPM-a. The card must be installed
on the CPM-a before you insert the CPM-a in the 7750 SR-a chassis.
Figure 36
shows the location of the CF card on the
features.
Figure 36: Location of Internal CF Card on CPM-a
Key
1
2
To install the CF card on the CPM-a:
Step 1. Remove the CF card from the packaging and place it on a flat antistatic work
surface.
Step 2. Remove the CPM-a from the packaging and place it on a flat antistatic work
surface. Hold the CPM-a by the edges. Do not touch the printed circuit board or
connector pins.
Step 3. Lift the card retainer bail (Key 1 on
Step 4. Insert the CF card (Key 2 on
Step 5. Close the card retainer bail to hold the CF card in the slot.
2
1
Table 48: CF Installation Features
Description
Card retainer bail
CF card (shown installed in the slot)
Figure
Figure
36) into the slot until it is fully seated.
Installing Components
CPM-a.Table 48
describes the installation
2
1
36) which covers the CF slot.
24558
111