3
4
7750 SR-a4 and SR-a8 Installation Guide
Figure 73: Removing an IOM-a
Key
Description
1
IOM-a positioned in the chassis slot guides
2
Threaded receptacle
3
IOM-a captive screws (one on each side of the IOM-a)
4
Ejector lever (one on each side of the IOM-a) in open position
Required tools:
•
#2 Phillips or flat blade screwdriver
To remove an IOM-a:
Step 1. Use a screwdriver to loosen the IOM-a captive screws (Key 3 in
Step 2. Grip both ejector levers and simultaneously pull the ejector levers outward to
unlock the IOM-a and to disengage the backplane connections (Key 4 in
Step 3. Slide the IOM-a out of the slot and place it on a flat antistatic work surface. Do not
touch the printed circuit board or connector pins.
Table 101: Removing an IOM-a Features
Appendix C: Field-Replaceable Units
2
1
3
4
24592
Figure
73).
Figure
73)
201