Installation and Replacement of Pluggable Transceivers
226
Step 2. Disconnect the network cable from the optical connector.
Step 3. Locate the bail in the front of the transceiver.
Step 4. Grasp the bail with your thumb and forefinger, and pull it downwards to disengage
the transceiver.
Step 5. Slide the transceiver out of the port, as shown in
Table 113
Figure 85: Removing an SFP, SFP+, CSFP, or QSFP+
Table 113: SFP, SFP+, CSFP, or QSFP+ Removal Features
Key
Description
1
SFP, SFP+, CSFP, or QSFP+ wire bail
2
SFP, SFP+, CSFP, or QSFP+ removal
Step 6. Place the transceiver on an antistatic mat or in an electrostatic bag.
Step 7. Remove the new transceiver from its antistatic packaging.
Note: If you are not replacing the transceiver with a new transceiver, you must reinsert a
plug into the transceiver receptacle.
Figure 85
5
L i n
k
A c
t
L i n
k
A c
t
1
7750 SR-a4 and SR-a8 Installation Guide
and described in
6
7
A c
t
L i n
k
A c
t
L i n
k
A c
t
L i n
k
2
24601