Telnet Connection; Figure 42 Cpm Console Port Connection - Alcatel-Lucent 7750 SR-a4 Installation Manual

Telnet Connection

7750 SR-a4 and SR-a8 Installation Guide
DTE
Pwr
Stat
Console
Console Port
To establish a console connection:
Step 1. Power on the terminal and set the emulation software to the parameters shown in
Table 53.
Step 2. Connect the terminal to the Console port on the front panel
serial cable. Note:
→ If you use a null modem cable, make sure that the switch beside the Console
port is set to DTE when connecting to the serial port of a PC.
→ If you use a straight-through cable, make sure that the switch beside the
Console port is set to DCE when connecting to the serial port of a PC.
Step 3. Establish the connection by pressing the <Enter> key a few times on your terminal
keyboard.
Step 4. At the router prompt, enter the login and password.
The default login is admin.
The default password is admin.
After a successful initialization, you can access the router with a Telnet connection from a PC
or workstation connected to the network, after the management port (see
configured using the bof>address command. Telnet access provides the same options for
user and administrator access as those available through the Console port.
To configure the 7750 SR-a for Telnet access, you need to have a device with Telnet software
located on the same network. The 7750 SR-a must have a management IP address. The IP
address is manually configured. Each 7750 SR router is limited to a total of seven inbound/
outbound Telnet or SSH sessions to guarantee that either inbound or outbound sessions will
be available. For information about configuring router parameters, refer to the appropriate
Router Configuration Guide. For pinout information, refer to
Assignments on page 211.
Powering Up, Initializing, and Configuring
Figure 42: CPM Console Port Connection
Lnk Act Lnk Act
Critical Major
DCE
Alarms
Minor
1PPS
ACO/LT Compact Flash
Appendix D: CPM-a Pinout
24564
(Figure 42) using the
Figure 43) has been
129