Telnet Connection; Figure 18: Management Port Connection - Alcatel-Lucent 7450 ESS-1 Installation Manual

Telnet Connection

Access the switch after a successful initialization with a Telnet connection from a PC or
workstation connected to the network after the management port
using the
and administrator access as those available through the console port.
To configure the 7450 ESS-1 for Telnet access, you need to have a device with Telnet software
located on the same network. The 7450 ESS-1 must have a management IP address. The IP
address is manually configured. Each 7450 ESS-1 switch is limited to a total of 7 Telnet or SSH
sessions. For information about configuring switch parameters, refer to the 7450 ESS OS System
Guide. For pinout information, refer to
MAC addresses are listed on a small label on the chassis and on the MDAs. The MAC address
also displays in the
CLI Syntax: bof
The ESS-1 must have a management IP address. The IP address is manually configured.
7450 ESS-1
command (see below). Telnet access provides the same options for user
bof>address
show router arp
Mgmt Port

Figure 18: Management Port Connection

address ip-address/mask [primary|secondary]
Connections and Configurations
Appendix B: Pinout Assignments on page
command output.
(Figure 18) has been configured
87.
Page 69
ESS1002