Software Reset; Forced Shutdown - NEC Express5800/R310e-E4 Maintenance Manual

Chapter 1 Maintenance
10.
Resetting and Clearing the Server
See this section if the server does not work or if you want to set BIOS settings back to the factory settings.
10.1

Software Reset

If the server halts before starting the OS, press <Ctrl> + <Alt> + <Delete> keys. Resetting the server clears all
the data in memory and restarts the server.
10.2

Forced Shutdown

Use this feature when an OS command does not shut down the server, POWER Switch does not turn off the
server, or software reset does not work.
Continue to hold POWER Switch of the server for at least four seconds. The power is forcibly turned off.
To turn on the power back again, wait at least 30 seconds after turning off the power.
Press the POWER switch for at least four seconds.
The server is forcedly powered off.
Express5800/R310e-E4, R320e-E4, R320e-M4, R310f-E4, R320f-E4, R320f-M4 Maintenance Guide (Windows)
Note Make sure that no processing is in progress when resetting the server.
Note If the remote power-on feature is used, cycle the power once to load the OS after
the power has been forcibly turned off, and then turn off the power again by
shutting down the OS.
10. Resetting and Clearing the Server
POWER Switch
113