NEC Express5800/R310e-E4 Maintenance Manual page 149

Chapter 2 Configuring and Upgrading the System
Click Additional properties.
6.
Specify the required settings, and then click OK.
Teaming mode
Static Teaming
Switch Independent
LACP
Load balancing mode
Address Hash
Hyper-V Port
Dynamic
Standby adapter
Select one adapter to be set to standby mode from the adapters in the team.
Setting all adapters to active mode is also possible.
Primary team interface
Any VLAN ID can be specified for the primary team interface.
Express5800/R310e-E4, R320e-E4, R320e-M4, R310f-E4, R320f-E4, R320f-M4 Maintenance Guide (Windows)
Configures static aggregation between the NIC and switches.
Configures teaming on the NIC side without depending on the switch
settings.
Configures dynamic aggregation between the NIC and switches.
Distributes the load based on IP addresses and port numbers.
Distributes the load to each of the virtual switch ports used by the
virtual machines.

Distributes the load based on IP addresses and port numbers in
sending.

Distributes the load same to "Hyper-V Port" in receiving.
3. Duplex LAN Configuration
149