Installation Of The - Barco HDF-W30LP User And Installation Manual

22. Removal and installation of the projector covers
How to remove the input cover
1. Release the two captive screws at the top and bottom left side of the input cover, using a flat screw driver.
Image 22-7
Captive screws input cover
2. Remove the input cover from the projector as follows:
a) gently pull out the right bottom corner (A) of the input cover,
b) then gently pull out the right top corner (B) of the input cover,
c) then move the input cover away from the projector (C).
Image 22-8
Input cover removal
22.5 Installation of the front cover
W
ARNING
Necessary tools
7 mm flat screw driver.
How to install the front cover
1. Check if the front filter is present.
2. Ensure that no lens is mounted.
3. Install the front cover of the projector doing the following:
282
B
A
:
This procedure may only be performed by qualified technical service personnel.
C
R5906730 HDF WLP SERIES 01/08/2017