Table of Contents
Advertisement
3. Installation process
3.3
Starting up and adjusting the system
Adjustment steps
1. Switch ON the projector. See "Power on projector", page 77
2. Select the input slot to which the source is connected. Do this by pressing the numeric key on the remote control unit or on the
local keypad, See "Source selection", page 83.
3. Zoom and shift the lens until the image is properly projected on the screen, Do this by using the "ZOOM" and "FOCUS" key on
the remote control unit or on the local keypad. If necessary, level the projector from side to side by turning the adjustable feet in
or out.
28
R5906730 HDF WLP SERIES 01/08/2017
Advertisement
Table of Contents
