Interface Standard; Network - Barco HDF-W30LP User And Installation Manual

18. Projector Control
How to set
1. Press Menu on the remote control (RCU) or on the local keypad to activate the menus and select Projector Control → Serial
Communication → Baudrate.
Image 18-6
Serial communication, baud rate
2. Press ENTER to toggle between the available baud rates.
The following baud rates can be selected:
- 9600
- 19200
- 38400
- 57600
- 115200

18.5.2 Interface Standard

What can be done?
The communication protocol for the communication between the projector and a computer can be set to RS232 or RS422.
How to set up
1. Press Menu on the remote control (RCU) or on the local keypad to activate the menus and select Projector Control → Serial
Communication.
The Serial Communication menu is displayed.
2. Use the ▲ or ▼ key to select Interface Standard.
Press ENTER to toggle between [RS232] or [RS422].
Image 18-7
Interface standard

18.6 Network

About a network connection
A network connection can be made via a wired connection or via the optional wireless unit.
Overview
• Introduction to a Network connection
• Wired DHCP set up
• Wired IP address set up
• Wired subnet mask set up
• Wired default gateway set up
• Wireless network activation
• Wireless access points selection and setup
• Wireless DHCP set up
• Wireless fixed IP address set up
• Wireless subnet mask set up
• Wireless default gateway set up
224 R5906730 HDF WLP SERIES 01/08/2017