Table of Contents
Advertisement
Image 6-11
3. Install the position plate onto the middle bracket as illustrated. Tighten the plate with an M4 hex screw.
Image 6-12
4. Slide the middle bracket into the grooves of the front plate. Pay careful to orient the middle bracket like indicated in the drawing
below (the three holes at the below of the bracket must be placed at the opposite to the front plate). Turn in a set screw (M3) as
indicated in reference 1.
Tip:
Put in place the screws, without tightening them, before slide the middle bracket. It is more easy to positioning the screws
when the middle bracket is not in place.
R5906730 HDF WLP SERIES 01/08/2017
6. Physical installation stand alone cooler
43
Advertisement
Table of Contents
