Table of Contents
Advertisement
Image 17-96
3D sync loop through
4. Press ENTER to toggle between [On] and [Off].
[On] : 3D SYNC OUT is directly routed from 3D SYNC IN
[Off] : the internal 3D sync signal is available on 3D SYNC OUT, native or inverted as indicated in the 'Invert 3D Sync Out' setting.
17.13.4 Upper limit for triple or double flash
What can be done?
The Upper limit for triple flash can be set. When the input frame rates are below this limit, the result will be displayed at triple frame
rate.
The Upper limit for double flash can be set. When the input frame rates are below this limit, the result will be displayed at double
frame rate.
How to set the limit
1. Press Menu on the remote control (RCU) or on the local keypad to activate the menus and select Alignment → 3D Glasses.
The 3D Glasses menu is displayed .
2. Press ENTER.
3. Use the ▲ or ▼ key to select Upper Limit for Triple Flash or Upper Limit for Double Flash.
Image 17-97
4. Press ENTER to toggle to another value.
For Triple flash the limit can set to 24, 25 or 30.
For Double flash the limit can set to 30, 48 or 50.
17.14 High End Systems Mirror
About the mirror
The digital mirror is DMX controlled. This control can be done via the projector or via Projector Toolset. External DMX control is still
possible. Almost any image can be displayed on almost any place in the room using the pan and tilt adjustments. Settings storing
per layout is possible.
Projector control activation
1. Press Menu on the remote control (RCU) or on the local keypad to activate the menus and select Alignment → High End Systems
Mirror.
R5906730 HDF WLP SERIES 01/08/2017
17. Alignment
217
Advertisement
Table of Contents
