Auto Detection - Barco HDF-W30LP User And Installation Manual

Image 13-34
3D status
2. Press ENTER to toggle between [On] and [Off].
[On] : 3D activated
[Off] : 3D deactivated

13.10.3 Auto detection

About auto detection
• Automatically detects the 3D format (Frame Packing, Side-by-Side, Top-and-Bottom) on HDMI sources, based on the content
of the HDMI Vendor Specific InfoFrame (if present). For a detailed explanation of the HDMI vendor specific InfoFrame, refer to
the HDMI 1.4a specification.
• Will select SENSIO
present.
• Does not support Frame Sequential modes (Single and Dual Channel).
• Is not available on other inputs (only on the inputs of the 3D input module) and will be grayed out.
Based on data in the InfoFrame and received feedback from the SENSIO
be selected:
3D format in InfoFrame
Frame Packing
Side-by-Side
Top-and-Bottom
No InfoFrame data present
How to activate/deactivate
1. Press Menu on the remote control (RCU) or on the local keypad to activate the menus and select Input → 3D → Auto detection.
4. NA:feedback from SENSIO Autodetect is not applicable in thes cases
®
R5906730 HDF WLP SERIES 01/08/2017
3D Decoder – FFC in case Side-by-Side or Top-and-Bottom mode is detected or if no InfoFrame data is
®
SENSIO
4
NA
Side-by-Side or SENSIO
Other
Top-and-Bottom
Other
4
NA
® Autodetect core, the following formats (Input Type) will
Autodetect feedback
®
® Hi-Fi 3D
Input type selected
Frame Packing (FHD3D)
SENSIO ® 3D Decoder – FFC
Side-by-Side (Half)
SENSIO 3D Decoder – FFC
®
Top-and-Bottom (Half)
SENSIO ® 3D Decoder – FFC
13. Input
127