Usb Memory; Reset Formatter - Barco HDF-W30LP User And Installation Manual

19.5 USB memory

Purpose
2 functions are available
• Custom settings can be saved on a USB stick.
• A selection of saved settings can be (down)loaded via an USB stick on the projector.
How to save custom settings
1. Press Menu on the remote control (RCU) or on the local keypad to activate the menus and select Service → USB Memory.
Image 19-32
USB memory selection
2. Select Save Custom Settings and press ENTER to download this set.
Note: Make sure a formatted USB stick is inserted in the USB connector.
When no USB stick is available, a message will be shown: No USB device is found.
The name of the custom settings files contains the serial number of the projector from which ti is downloaded.
Load custom settings
1. Press Menu on the remote control (RCU) or on the local keypad to activate the menus and select Service → USB Memory.
Image 19-33
USB memory selection
2. Select Load Custom Settings and press ENTER.
An overview of the available sets of custom settings is given.
Image 19-34
Custom settings files
3. Select a set and press ENTER to upload this set.

19.6 Reset Formatter

Why and when
A reset formatter is necessary when e.g. a color is missing, artifacts are visible in the image or image is frozen and the formatter
test patterns cannot be displayed.
How to reset
1. Press Menu on the remote control (RCU) or on the local keypad to activate the menus and select Service → Reset Formatter.
The Reset Formatter menu is displayed.
2. Press ENTER to select. Use the ▲ or ▼ key to select Yes. or No and press ENTER.
R5906730 HDF WLP SERIES 01/08/2017
19. Service
265