Table of Contents
Advertisement
14. Image
Image 14-36
Image file services
2. Press ENTER to select.
Depending on the File Load Filter setting a full list or a list fitting the selected source is displayed.
When staying for at least 3 seconds on the same file selection after scrolling through the list of image files a pre-load is started.
Image 14-37
Load file
3. Use the ▲ or ▼ key to select the desired file and press ENTER to load this file.
The image is not perfect
If the displayed image is not correct after selecting the best fitting file, go to the Timings menu and change the file settings.
14.6.3 File Load Filter
About the filter setting
Depending on the load file filter, the load list can be reduced to the fitted files or can be expanded to show all files.
[Fit] : reduced list corresponding with the input source.
[All] : full list with all available files in the projector.
How to set up
1. Press Menu on the remote control (RCU) or on the local keypad to activate the menus and select Image → Image File Services
→ File Load Filter.
Image 14-38
File load filter
2. Press ENTER to toggle between [All] and [Fit].
14.6.4 Delete a file
What can be done ?
A custom image file can be deleted. Be aware that an active file can't be deleted.
148
R5906730 HDF WLP SERIES 01/08/2017
Advertisement
Table of Contents
