Usb Memory - Barco CLM HD8 User Manual

14. Service menu
What can be done?
When all preparations are taken, the refill mode will automatically activate the refill process.
How to start the refill mode
1. Press MENU to activate the menus.
2. Use the ▲ or ▼ key to select Service and press ENTER.
The service window opens.
3. Use the ▲ or ▼ key to select Refill mode and press ENTER.
A refill confirmation message is displayed.
4. Use the ▲ or ▼ key to select Yes or No and press ENTER.
Yes will switch the projector in refill mode.
When No is selected, the projector stays in normal mode.
Image 14-43
When the projector was in standby while selecting Refill mode, then the water-cooling pump will start pump-
ing. Repower the projector to finish the refilll mode.
When the projector was playing, it remains playing.

14.8 USB memory

What is possible with an USB device?
An USB device, FAT 16 formatted can be used, to save custom settings from the projector or to load custom settings to the projector.
This function is very handy to clone projectors.
The following settings can be transported via an USB device:
• baudrate
• address
• common address
• orientation
• text on/off
• file load mode
• eco mode & dimming
• rs232 interface & rs232 termination
• no signal setup settings
• IR receiver settings
• native resolution
• min delay
• current language of on screen menus
• customer id
• Network settings (DHCP, IP address, net mask, gateway address)
• blanking & keystone
• ScenergiX
156
Image 14-44
Image 14-45
R59770057 CLM HD8 14/01/2009