1000 Hour Lubrication And Maintenance Checks - Komatsu 830E Shop Manual

1000 HOURS LUBRICATION AND MAINTENANCE CHECKS
Maintenance for every 10, 250 & 500 hour Lubrica-
tion and Maintenance Checks should also be carried
out at this time.
NOTE: "Lube Key" references are to the Lubrication
Specification Chart.
1. HYDRAULIC TANK - Drain hydraulic oil* and
clean inlet strainer. Refill tank with oil, approxi-
mate capacity 238 gal. (901 liters). Use Lube
Key "B".
* NOTE: Oil change interval can be extended to 2500
hours if oil is sampled at regular intervals.
Hydraulic Tank Breather - Replace breather.
2. RADIATOR - Clean cooling system with a quality
cleaning compound. Flush with water. Refill
system with anti-freeze and water solution.
Check Cooling System Recommendation Chart
for correct mixture. Refer to engine manufac-
turer's manual for recommended additives.
3. FUEL TANK - Remove breather and clean in
solvent. Dry with air pressure and reinstall.
4. OPERATOR'S SEAT - Apply grease to slide
rails. Use Lube Key "D"."
5. AUTOMATIC BRAKE APPLICATION - Check
that brakes are automatically applied when
hydraulic brake pressure decreases below
specified limit. Refer to Section "J", "Brake
Checkout Procedure".
6. FRONT ENGINE MOUNT TRUNION - Add one
or two applications of grease at fitting. Lube key
"D".
7. AUTOMATIC LUBE SYSTEM PUMP - Check
pump housing oil level. Refill to bottom of level
plug with SAE 10W-30 motor oil.
8. ELIMINATOR FILTER - Clean and check centri-
fuge. Refer to engine manufacturer's Operation
and Maintenance Manual. (Service interval is
dependent on duty cycle, oil quality etc.)
P02039
Truck Serial Number_________________________
Site Unit Number ___________________________
Date:_______________ Hour Meter: ____________
Name of Service Person _____________________
Lubrication and Service
COMMENTS
√ √ √ √ 'd
INITIALS
P2-11