Software Installation Preparation - Komatsu 830E Shop Manual

SOFTWARE INSTALLATION PREPARATION

The software code disk contains the operating software
in compressed form which is automatically expanded
as the main file is copied to the PTU hard drive.
The following files are located on the disk:
STATEX III Enhanced, Version 1.0
•
502ddg1.exe
This file contains the Enhanced Version 1.00
software for use with trucks equipped with the
17FB144 CPU card.
•
Install1.bat
A batch file to be selected to start software
installation on the PTU if the PTU communi-
cates with the truck through COM port 1.
•
Install2.bat
A batch file to be selected to start software
installation on the PTU if the PTU communi-
cates with the truck through COM port 2.
•
Readme.txt
A text file describing the software version and
instructions for installing the software program.
STATEX III Version 14.00
•
502dbg1.exe
This file contains the Version 14.00 software for
use with trucks equipped with the 17FB101
CPU card.
•
Install1.bat
A batch file to be selected to start software
installation on the PTU if the PTU communi-
cates with the truck through COM port 1.
•
Install2.bat
A batch file to be selected to start software
installation on the PTU if the PTU communi-
cates with the truck through COM port 2.
•
Readme.txt
A text file describing the software version and
instructions for installing the software program.
Either of the above software disks is used to update the
March 1996, Version 12.10 software release or can be
installed on a new PTU for use with the appropriate
truck, depending on the CPU card installed. Since both
versions may be required for some trucks in a fleet
equipped with the FB101 card and others equipped
with the FB144 card, the Enhanced version 1.00 and
version 14.00 are automatically installed in different
directories on the PTU.
E2-22
HARD DISK SPACE REQUIREMENTS
Software installation will require approximately 3.2
megabytes of disk space on the PTU hard disk. Addi-
tional space will be required for saving event and sta-
tistical data. Be certain there is enough disk space
available.
Inadequate disk space will prevent all the required
files from loading and the software will not operate
properly!
If older versions of the software must be deleted to
make space, backup all data to be retained (i.e statisti-
cal data) before deleting. Do not delete truck configura-
tion files as they will be updated using the new version
of software
SOFTWARE INSTALLATION ON PTU
The following instructions describe the procedures for
initial installation of the GE software on the PTU or pro-
cedures to update the PTU with the latest version soft-
ware code. It is not necessary to connect the PTU to
the truck during software installation.
NOTE: To determine the latest version of software
code, contact your Komatsu Distributor. If new code is
required, the current disk can be obtained.
Use the following procedure when initially installing the
GE software on the PTU hard drive or if updating the
current software to a new release version.
1. The computer must be at any DOS prompt prior
to installing the software.
2. Insert the diskette into the computer diskette
drive.
3. If the floppy disk drive containing the diskette is
designated drive "A", type "a:install1" if COM 1 is
used for attaching the serial cable to the truck for
communication or type "a:install2" if COM 2 is
used for communication. Press [ENTER] to start
the software installation process.
Electrical Propulsion Components 2/02 E02016