BRAKE BLEEDING PROCEDURE
Attach brake lines and bleed brake calipers according
to the following instructions:
1. Fill hydraulic tank following procedure in Section
"P", Hydraulic Tank Service.
2. Close brake accumulator drain valves (7, Figure
6-19), if open.
3. Securely attach bleeder hose to highest bleeder
valve of each caliper, direct hose away from
brake assembly and into a container to catch
excess oil.
4. With engine at idle make partial brake application
of service brake pedal:
a. Maintaining partial application, open bleeder
valve until a clean stream of oil is discharged
from caliper.
b. Close bleeder valve.
5. Repeat above Steps until all air is bled from all
calipers.
J6-18
All new brake linings must be burnished prior to
being put in service. Refer to "Service Brake Con-
ditioning".
Rockwell Armature Speed Rear Disc Brakes
6. Check hydraulic reservoir level as bleeding takes
place, maintain correct level.
7. Before returning truck to production, brake lining
must be burnished.
J06020